Common PC issues and their solutions:
1. Monitor LED is blinking:
Check all the connections like Monitor Cable, Data cables, RAM, Display Card, CPU connections sometimes loose connection may cause this type of problem.
2. Continuous Three Beeps:
Problems in RAM connection. Beeping sound are mostly produced from RAM
3. Three Beeps (1 Long 2 Short):
Problem in Display Card connection...Make It clean.
4. Three Long beeps period wise:
Problem in BIOS or RAM (Basic Input Output system) (Random Access Memory)
5. Continuous Non Stop Beeping:
Key Board Problem (I.e; some key is pressed for longer time)
6. FDD LED is glowing continuously:
Data Cable to be connected properly (twisted cable). Do not use breakable wire.
7. No Display on the screen at all:
Hard Disk cable connected wrongly. Connect rightly seeing the red mark (Faces Power supply) and then Restart check it from CPU to monitor.
8. Power LED is off:
a. Check Main power cord
b. Check S.M.P.S
c. Check Mother Board connection
d. Check once again at CPU and Monitor
9. Showing CMOS error:
Replace 3 Volt battery of Mother Board. Set original settings Manually. (Refer-CMOS setup chart) Enter your search terms. Submit search form.
10. Showing FDD error or Floppy drive is not working properly.
Check Power Cord of FDD, Data Cables, set CMOS & finally check the drive.
1. Monitor LED is blinking:
Check all the connections like Monitor Cable, Data cables, RAM, Display Card, CPU connections sometimes loose connection may cause this type of problem.
2. Continuous Three Beeps:
Problems in RAM connection. Beeping sound are mostly produced from RAM
3. Three Beeps (1 Long 2 Short):
Problem in Display Card connection...Make It clean.
4. Three Long beeps period wise:
Problem in BIOS or RAM (Basic Input Output system) (Random Access Memory)
5. Continuous Non Stop Beeping:
Key Board Problem (I.e; some key is pressed for longer time)
6. FDD LED is glowing continuously:
Data Cable to be connected properly (twisted cable). Do not use breakable wire.
7. No Display on the screen at all:
Hard Disk cable connected wrongly. Connect rightly seeing the red mark (Faces Power supply) and then Restart check it from CPU to monitor.
8. Power LED is off:
a. Check Main power cord
b. Check S.M.P.S
c. Check Mother Board connection
d. Check once again at CPU and Monitor
9. Showing CMOS error:
Replace 3 Volt battery of Mother Board. Set original settings Manually. (Refer-CMOS setup chart) Enter your search terms. Submit search form.
10. Showing FDD error or Floppy drive is not working properly.
Check Power Cord of FDD, Data Cables, set CMOS & finally check the drive.
No comments:
Post a Comment